View Single Post
Old February 9, 2013, 06:39 PM   #12
unknwn
Member
 
Join Date: January 20, 2011
Posts: 25
Put an extension on your socket/nipple tool , put the cylinder on a block of wood -or- similiar, put the tool on the nipple and hammer on it (the extension).
The -shock- of hammering on it will loosen it up almost every time.
If it didn't work, heat it up either with a propane torch or similiar -or- in a pan of boiling water -and- repeat the hammering trick again.
unknwn is offline  
 
Page generated in 0.03670 seconds with 8 queries