View Single Post
Old December 2, 2012, 11:37 AM   #10
Misssissippi Dave
Senior Member
 
Join Date: December 5, 2009
Posts: 1,411
Quote:
the other small issue is the threaded ram arm keeps loosening. I think I will try some Lock tight thread locker...
If you are referring to the handle, it is easy to tighten down. There is a hole in the handle shaft. I place a philips tip screw driver in mine then tighten the nut. It works well for me. I use the original ball handle and that hole provides me a way to be able to really crank it down if needed.
Misssissippi Dave is offline  
 
Page generated in 0.02648 seconds with 8 queries