View Single Post
Old December 14, 2012, 11:00 PM   #21
LOUD
Senior Member
 
Join Date: May 29, 2010
Location: Virginia
Posts: 236
the rockwell test was done on the bottom of the receiver just below the feed ramp behind the front ring , several little pock marks perfectly round . I can attest that the front and rear ring are very hard . The company rep said I could have it barreled by a local gunsmith and be fine. As a legal requirement they had to meet that criteria. Should I go ahead ?
LOUD is offline  
 
Page generated in 0.02677 seconds with 8 queries