I shoot a .50 BMG.
How about some molds for that ?
Not much out there for .50 BMG rifles.
Spitzer bullets in the 600-800 grain range would be great. They'd probably need to have a gas check arrangement due to the speeds involved. A double cavity mold would be nice.
Id buy some in a heartbeat.
Just a thought...
One might be able to use some half inch copper tubing for a jacketed bullet. A mold that could incorporate this would be an exellent idea.
One could then cast jacketed lead bullets and not have to worry about leading.
That would be some cheap shooting for a .50 BMG.
If nothing else, they would make great short range plinking loads, say to 600 yards or so.
|