Well I finally got to shoot. I still had 50rds of reloads left. Still had misfires. This time on each misfire I noticed light primer strikes and then rechambered and fired, separated those misfires brass to measure later. I still had about 1 or 2 per mag. I also ran 20rds of factory, and all fired/functioned normally. The factory brass length was avg of .890. My problem brass was around .880-.885. I do know this is under specs of .888, (was cut too short years ago). I am starting to think this 1911 does not like short brass, and may cause a headspace issue. This brass has always ran fine in my XD. I have marked this batch of brass to run through my other 45s later to see what happens. Most likely I will probably end up tossing them so they don't get used in the 1911 again. Its not going to hurt my brass supply any.
|