The Firing Line Forums - View Single Post

sc928porsche · February 5, 2012, 10:14 PM

Through the years I have ended up with a lot of different mfg dies. Some Redding, Lyman, RCBS, Forrester, CH, and Lee etc. The greatest majority of them are Lee. I like the fact that you can remove a stuck case with a plastic mallet, and also the through-powder expanding die. I also dont have to replace any broken primer pins. They are also a lot less expensive (notice I didnt say cheap).

February 5, 2012, 10:14 PM	#62
sc928porsche Senior Member Join Date: May 29, 2008 Location: now living in alabama Posts: 2,433	Through the years I have ended up with a lot of different mfg dies. Some Redding, Lyman, RCBS, Forrester, CH, and Lee etc. The greatest majority of them are Lee. I like the fact that you can remove a stuck case with a plastic mallet, and also the through-powder expanding die. I also dont have to replace any broken primer pins. They are also a lot less expensive (notice I didnt say cheap). __________________ No such thing as a stupid question. What is stupid is not asking it. Last edited by sc928porsche; February 5, 2012 at 10:20 PM.