View Single Post
Old December 18, 1999, 12:43 AM   #4
Mal H
Staff
 
Join Date: March 20, 1999
Location: Somewhere in the woods of Northern Virginia
Posts: 16,939
That's a very good question. I am probably not the one to give you a definitive answer because I haven't tried to fully optimize a round to be the tack in a tack driver. Others may have better info. (Gale McMillan are you listening in?) I usually back off .007 to .015 assuming the bullet/case combo will allow it getting that close. Some folks seat the bullet right up to the lands and some even jam it into the lands. I would be very leary of the latter due to unknown effects on pressure.
Mal H is offline  
 
Page generated in 0.03737 seconds with 8 queries