View Single Post
Old July 22, 2011, 06:53 PM   #1
colostomyclown
Senior Member
 
Join Date: February 22, 2009
Posts: 613
Wingmaster locked up

So, I disassembled my Wingmaster after not having taken an 870 down in a few years. Everything went fine, I went to reassemble, put slide and bolt assembly into the receiver, and went to put in the trigger assembly elevator and noticed that the forward pin did not line up. The shell stop on the right side of the receiver looks like it's slammed forward a bit and blocked the pin from going through the receiver on right side. I got the trigger guard out but now the slide and bolt assembly seem stuck inside the receiver.

what to do now?
colostomyclown is offline  
 
Page generated in 0.03531 seconds with 8 queries