View Single Post
Old November 6, 2011, 09:43 AM   #14
niemi24s
Junior Member
 
Join Date: November 2, 2011
Posts: 6
One (hopefully) last question if you don't mind.

From the dimensions on the drawing in Post #9, the "depth" of the average Ordnance 45 Auto extractor hook is 0.4655 - 0.4335 = 0.032". Because the average SAAMI 45 Auto case extraction groove is 0.040" deep, this extractor is designed to apply pressure to edge of the case rim - not the bottom of the groove.

Q: What is the average "depth" of the S&W 45 Auto extractor hook (or, stated another way, is it designed to apply pressure to the edge of the case rim or to the bottom of the 0.040" deep groove)?

Best Regards

Last edited by niemi24s; November 8, 2011 at 05:58 PM.
niemi24s is offline  
 
Page generated in 0.02632 seconds with 8 queries