View Single Post
Old November 26, 2009, 08:50 PM   #4
Harry Bonar
Senior Member
 
Join Date: December 5, 2004
Location: In the Vincent, Ohio general area.
Posts: 1,804
extractor

Sir;
Correct, the S&W extractor cannot be adjusted - but - remove it from the pistol carefully and on the very bottom behind the hook take a needle file and cut a very small angle (just break the sharp edge) and then gently polish it with some very fine grit.
This will let the case rim slip up under the extractor hook easier.
Harry B.
Harry Bonar is offline  
 
Page generated in 0.02456 seconds with 8 queries