Quote:
|
Could the barrel be canted with respect to the frame?
|
It is a possibility, I will have to square the gun up and check the front sight with a machinists square or something.
I once had a three-screw Ruger Super Black-hawk that had the front sight silver soldered on at an obvious angle. I had to adjust the rear sight pretty far over to compensate for it. Using a six-inch steel ruler as a straight edge along the side of the sight, the steel rule extended the angle and it was pretty far off from vertical. With this Colt, it is hard to tell if the barrel is canted or if the sight is slightly bent...I will have to examine it further.