The Firing Line Forums - View Single Post

Rangefinder · October 27, 2012, 11:13 AM

Here's a couple I've done reciently so you can get some idea how the traditional "spud" in a HP mold works and some of the options you may have.

"Devastator" in .358

Same mold fitted with an adjustable pin (sleeved to decrease pin diameter and give a little extra integrity to the nose). Pin can be adjusted to the rear lube groove for deep-cavity HP or backed out to nothing more than a dimple in the nose. (not the type of thing that happens at the factory, however)

October 27, 2012, 11:13 AM	#3
Rangefinder Senior Member Join Date: August 4, 2005 Posts: 2,017	Here's a couple I've done reciently so you can get some idea how the traditional "spud" in a HP mold works and some of the options you may have. "Devastator" in .358 Same mold fitted with an adjustable pin (sleeved to decrease pin diameter and give a little extra integrity to the nose). Pin can be adjusted to the rear lube groove for deep-cavity HP or backed out to nothing more than a dimple in the nose. (not the type of thing that happens at the factory, however) __________________ "Why is is called Common Sense when it seems so few actually possess it?" Guns only have two enemies: Rust and Politicians.