View Single Post
Old September 5, 1999, 05:37 AM   #3
Colduglandon
Senior Member
 
Join Date: March 5, 1999
Location: Mass
Posts: 493
If you use the scoops pick up the Lee manual. I use them all the time for rifle loads, but I use a scale from time to time to check the poweder measure I am getting. If the technique you use with the scoop varies it can cause the amount of powder to vary as well especially with extruded powder. The Lee dies are a good choice because they include the factory crimp die which is beneficial when you are using a tubular magazine. Check Wideners for bullets. They have had good specials on Winchester 150 grain round nose bullets in the past.
Colduglandon is offline  
 
Page generated in 0.01905 seconds with 8 queries