The Firing Line Forums - View Single Post - slide not locking with new mag -- dremel it?

cogito · January 23, 2013, 10:08 PM

Howdie,

I just bought some Pachmayr mags for my Sig P226. They feed without issue, but the slide doesn't lock after the first round.

Looking at the mag, the metal gap where the slide lock would hit is a bit narrow as is the corresponding place on the follower.

So, I presume I could just open it up a bit with a dremel. Any advice?

January 23, 2013, 10:08 PM	#1
cogito Member Join Date: October 16, 2012 Location: Mid-Western State Posts: 37	slide not locking with new mag -- dremel it? Howdie, I just bought some Pachmayr mags for my Sig P226. They feed without issue, but the slide doesn't lock after the first round. Looking at the mag, the metal gap where the slide lock would hit is a bit narrow as is the corresponding place on the follower. So, I presume I could just open it up a bit with a dremel. Any advice?