Thread
:
help, having Problem when bullet seating/crimping
View Single Post
March 13, 2012, 04:03 PM
#
9
Ethan.G
Senior Member
Join Date: March 13, 2012
Posts: 127
alright that makes sense, im using a FL sizing die but ill check it again and holding it down makes sense too, thanks.
Also im not sure if the "decapper" in said die is set properly, is it possible to have it too low? if so would it cause a problem?
Ethan.G
View Public Profile
Find More Posts by Ethan.G
Page generated in
0.03764
seconds with
8
queries