View Single Post
Old February 1, 2011, 12:24 PM   #4
zippy13
Senior Member
 
Join Date: August 23, 2008
Location: SoCal
Posts: 6,442
Your problem may be different, but your success (or lack thereof) with factory service is the same.

Something you didn't mention, has anything been done with the trigger group? It sounds like the factory addressed firing pin drag and improper lock-up problems; but, you don't know if they did anything about the hammer fall. Perhaps if you temporarily borrow the trigger group from your dad's gun, you may learn something.
zippy13 is offline  
 
Page generated in 0.02273 seconds with 8 queries