The Firing Line Forums - View Single Post - Need new Uberti Walker nipples for #10 caps

mykeal · March 3, 2008, 05:20 PM

Looking forward to seeing what you actually get from the Possible Shop.

I have two Treso 11-50-13's and they are definitely 1/4x28 threads. And they fit (thread wise) all four of my cylinders - both Ubertis, the ASM and the Colt. All Ubertis fo not take 12x28 threaded nipples - at least two of mine don't.

I checked Jedediah Starr's site and found Treso 11-50-13's were listed as 1/4x28.

I think you will get 1/4x28 threaded nipples and they will go in your cylinder just fine. If you have a nipple wrench that will fit them. And if they are not too short for the hammer to strike the cap.

I'm not so sure the problem is at Thunder Ridge; it may well be at the Possible Shop. It will be interesting ...

March 3, 2008, 05:20 PM	#16
mykeal Senior Member Join Date: October 8, 2006 Location: Northern Michigan Posts: 2,772	Looking forward to seeing what you actually get from the Possible Shop. I have two Treso 11-50-13's and they are definitely 1/4x28 threads. And they fit (thread wise) all four of my cylinders - both Ubertis, the ASM and the Colt. All Ubertis fo not take 12x28 threaded nipples - at least two of mine don't. I checked Jedediah Starr's site and found Treso 11-50-13's were listed as 1/4x28. I think you will get 1/4x28 threaded nipples and they will go in your cylinder just fine. If you have a nipple wrench that will fit them. And if they are not too short for the hammer to strike the cap. I'm not so sure the problem is at Thunder Ridge; it may well be at the Possible Shop. It will be interesting ...