|
OK. If there is no spring tension on the trigger the bolt/trigger spring is likely the culprit. It's almost impossible to install upside down but I suppose you could do it. Anyway try this remembering that the long leg goes to the trigger and the short leg goes over the bolt. With the hammer down hold the trigger forward against the hammer and lay the spring in place with the tip to the trigger side on the flat of the trigger that holds it then start the screw and tighten it down making sure the spring does not come off that flat and go under it which results in no tension on the trigger.
From your previous post it sounded like you had replaced the hand and you didn't mention no spring tension on the trigger. Makes it hard to diagnose the problem when you leave out details like that.
|