View Single Post
Old March 12, 2013, 05:31 PM   #1
nigsbro
Junior Member
 
Join Date: March 12, 2013
Posts: 2
any of you guys use a mec automate?

I know its alot to ask but over here in the uk there isnt anyone I can ask. could someone take some messurements for me in iches or mm off their auto-mate please? as been looking around now for weeks with no luck,
the messurements I need are below.
depth
slope size,
front hight up to slope
rear hight
disk size aross disk
center of the disk to the conecting arm bolt
lenght of drop arm from disk bolt to upper bolt thats on the rear of the press
and thickness of steel used for the auto mate and the disk.

If someone could do this for me it would be a great help as im trying to make a 12volt unit up.
nigsbro is offline  
 
Page generated in 0.03433 seconds with 8 queries