View Single Post
Old March 6, 2011, 11:24 PM   #6
NESHOOTER
Senior Member
 
Join Date: October 16, 2009
Posts: 517
Quote:
My question is that given the age of the brass (it did not sit out in the weather - almost no oxidation) are there any special considerations I should take in the prep?
As with most military brass I have used it would be good to FL size it and make sure there is no berdan primed primers if you look into the case it will have 2 holes you can see and if you do your decapper pin will not take it and break just throw them in recycle brass to sell. Once you remove the primer care must be taken to remove the ''Crimp'' on the primer pocket. Then trim to recommended length and trim, chamfer/deburr the neck. And Happy reloading I use mixed brass only for plinking and on my more serious targeting I use only the same type of cases for accurracy needs.

Last edited by NESHOOTER; March 6, 2011 at 11:25 PM. Reason: spe
NESHOOTER is offline  
 
Page generated in 0.03787 seconds with 8 queries