View Single Post
Old February 1, 2013, 09:27 PM   #32
Gunplummer
Senior Member
 
Join Date: March 11, 2010
Location: South East Pa.
Posts: 3,364
It works if you watch not to thin out the chamber wall too much. I would not advise welding a barrel, but in this case I think he will be fine because of the low pressure round. It amazes me how people are scared @#$%less of heating up a bolt to weld a handle on but will break out the welder the minute they have a barrel problem. Welding on a high power barrel will either anneal the barrel or harden it more, but it will not "Do nothing".
Gunplummer is offline  
 
Page generated in 0.02144 seconds with 8 queries