View Single Post
Old February 1, 2012, 10:14 AM   #29
Edward429451
Junior member
 
Join Date: November 12, 2000
Location: Colorado Springs, Colorado
Posts: 9,494
I believe the plastic part was factory, that sounds like something Lee would do, lol. There are so many ways to make dies that it's not funny. I have three generations of RCBS 44 dies, each set differing in operation from the others. (in one set, die #1 resizes only, die #2 decaps the primer and expands the case mouth, #3 is a seater).

I have a good assortment of brands, I suppose I like RCBS the best because its what I have the most of and use the most. I also have Lyman, Lee, Hornady, Dillon, Pacific Durachrome, and C-H.

Tool and die maker...plastic. Tool and die maker...plastic. That aint right!
Edward429451 is offline  
 
Page generated in 0.02625 seconds with 8 queries