View Single Post
Old July 24, 2010, 07:45 PM   #1
swmike
Senior Member
 
Join Date: June 25, 2005
Location: Marysville, WA
Posts: 670
Scope mount conceals serial number

I'm preparing to mount a leupold 1-piece (std) base on a 1903 A3 action. When I place the base on the action to check the fit, the serial number is almost totally concealed. I have considered the following:

Alter the mount by beveling the right side, thus exposing the serial number. This would result in the loss of approximately 1/3 of the mounting surface. Since the serial number is long (326XXXX) and the characters are about 3/16" in height (typical military fashion) any "window" would have to be quite large.

Go ahead and mount the base and then just engrave a second set of numbers below the original in order to have a visible number.

Mount the base and just cover the number, realizing that anytime someone wanted to see the serial number I would have to remover the base.

Any comments or suggestions (short of suggesting a different base)?
__________________
My definition of Gun Control--- A steady grip and hitting your target.


"In God we trust, all others are suspects."

"If I shoot all the ammo I am carrying, either I won't need any more, or more won't be of any help".

____________________________________________
swmike is offline  
 
Page generated in 0.03184 seconds with 8 queries