View Single Post
Old November 6, 2012, 06:10 PM   #10
hooligan1
Senior Member
 
Join Date: July 18, 2010
Location: Independence Missouri
Posts: 4,582
Alot of windage problems come from the rear ring not properly aligned. When I mount any scope I too remove the bolt and center my bore on an object 75 to 100 yds distant, and check the crosshairs, if there is a windage problem I adjust the rear ring.
The OP said he "boresighted" the scope after mounting it, and it still wasn't on paper, this tells me it wasn't properly "boresighted". good luck.
__________________
Keep your Axe sharp and your powder dry.
hooligan1 is offline  
 
Page generated in 0.02746 seconds with 8 queries