View Single Post
Old March 22, 2013, 01:24 AM   #24
craZivn
Senior Member
 
Join Date: January 25, 2013
Location: Wisconsin
Posts: 138
Thanks for the tips Dragline and Oldgunsmith! I polished my internals according to the guide on Teslamap, and took great care to polish only a little and used a low speed. I actually think I did not polish as much as it could have used, as there was almost no noticeable difference in the trigger pull after I was done. But I'll stay away from the Dremel in the future, thank you for the heads-up!

As far as the loose trigger guard goes, nothing I polished has any interaction with the latch or the hole it locks into, so I'm sure that it was not caused by the polishing.

Ivan
craZivn is offline  
 
Page generated in 0.02310 seconds with 8 queries