View Single Post
Old May 16, 2012, 08:33 AM   #7
animal
Senior Member
 
Join Date: April 28, 2000
Location: Mississippi
Posts: 705
V -block was my thought at first glance too … but the picture looks like the channels aren’t machined to hold a clamp and the cuts that would be "V" aren’t deep enough to hold much of anything. Important surfaces are the flats, imo
Dunno what they’re for … but with 2 in 11/16 x 13/16 x 4" … might be handy as super-duty parallel bars, especially in a 1" deep vise ,,, ?
__________________
Keep smiling ... it'll just make 'em wonder what you're up to...

Last edited by animal; May 16, 2012 at 08:41 AM.
animal is offline  
 
Page generated in 0.03667 seconds with 8 queries