View Single Post
Old June 13, 2013, 09:57 AM   #8
Jerry45
Senior Member
 
Join Date: April 18, 2000
Location: Metairie, Louisiana
Posts: 890
zplinker, thanks for the advice. I'm using shim washers to time it. No lathe here. I had to use a "short", 4", brass bar to get it timed. It's perfectly level with the horizontal line of the scope. It's not extremely tight but tight enough I couldn't brake it loose by holding the barrel with my hand. Next time I'll bring a pipe wrench with me. (joking)

Edit to add, I re-shimed it. It's now "hand tight", timed and location marked so I csn return it to same position.
__________________
Guns are not dangerous! People are! RKBA!

Last edited by Jerry45; June 13, 2013 at 04:10 PM.
Jerry45 is offline  
 
Page generated in 0.03260 seconds with 8 queries