The Firing Line Forums - View Single Post - Neck turning Brass

croc4 · May 23, 2006, 11:15 AM

When neck turning brass, how far is too far?, do you turn the neck until the neck is all shaved evenly (all shiney new brass), I tried a few test shells last night and noticed that there were still a few small places that were not touched by the cutter, and wasn't sure how far was too far when trimming the necks

May 23, 2006, 11:15 AM	#1
croc4 Senior Member Join Date: March 9, 2006 Location: Idaho Posts: 191	Neck turning Brass - question When neck turning brass, how far is too far?, do you turn the neck until the neck is all shaved evenly (all shiney new brass), I tried a few test shells last night and noticed that there were still a few small places that were not touched by the cutter, and wasn't sure how far was too far when trimming the necks