The Firing Line Forums - View Single Post

savagest · June 3, 2013, 12:13 AM

Pretty much a success. I found a few loads I might start to make. Overall good day.

My question is I am using Federal brass that came with their Match .308 ammo. I started to get some ejector marks on some of my loads near maximum. Primers look fine, not cratered or leaking. Am I in the safe zone? The ejector marks are just visible, I can't feel them.

And can I reuse the brass if it has these marks?

June 3, 2013, 12:13 AM	#1
savagest Senior Member Join Date: February 9, 2013 Posts: 110	Shot my first reloads. Ejector marks. Pretty much a success. I found a few loads I might start to make. Overall good day. My question is I am using Federal brass that came with their Match .308 ammo. I started to get some ejector marks on some of my loads near maximum. Primers look fine, not cratered or leaking. Am I in the safe zone? The ejector marks are just visible, I can't feel them. And can I reuse the brass if it has these marks?