View Single Post
Old June 21, 2011, 08:51 PM   #3
TrooperLX
Junior Member
 
Join Date: June 20, 2011
Posts: 2
That sounds similar to what I was trying with my Auto Glass Hook Tool. I would stick the hook end into the larger hole above the pin hole that keeps the trigger in place. I would try to keep it down, but the trigger mounting pin hole would never quite line up. The holes were very close, but it was almost as if the spring was maxed out. I know that somehow the spring can have another 1/8" of an inch squeezed out of it the line up. It's almost as if I need an extra hand to drop the pin in. I will try the slave pin idea though and get back you on that. Thank you for your time Jim.
TrooperLX is offline  
 
Page generated in 0.03365 seconds with 8 queries