View Single Post
Old January 18, 2006, 01:49 PM   #6
CINDERDICK
Junior Member
 
Join Date: July 15, 2000
Location: ST LOUIS MO. USA
Posts: 2
What happened to my rockchucker

Here is how I handled the problem you describe:

(1) Go to your local ice cream shop (Dairy Queen, Mr Softie. Twisters etc)

(2) Get one of the plastic straws they issue with their products. (These are a little larger in diameter than fountain drinks).

(3) Tuck the straw in the groove in press ram after cutting it about 1/4 to 3/8th inch shorter the the length of the ram groove, with the top end just under the shellholder in the ram. Cut the bottom of straw at an angle with the angle facing the rear of the groove in ram, CHECK TO MAKE SURE IT CLEARS as the ram moves up & down.

Now the spent primer falls down the tube (straw) and just rolls out in primer catcher. NO MESS ON FLOOR.

AND IT'S FREE.
CINDERDICK is offline  
 
Page generated in 0.02531 seconds with 8 queries