View Single Post
Old October 11, 2011, 05:43 PM   #9
res45
Senior Member
 
Join Date: September 15, 2007
Location: NC
Posts: 753
Quote:
Is it hard to use the hand held reamer and still get a perfect pocket size without ruining it to where the primers don't fit anymore
I guess it possible but I've done over 1K cases and had no issues. The Hornady tool is already set to the correct depth for L and S primer pockets you can't cut the pocket any deeper. The cutter is on the sides and cuts the pockets to SAMMI specifications,but I've noticed very little brass being remove from the inside of the primer pocket.

The bevel portion of the cutter remover just enough brass to remove the crimp ring. I've using it with LC 7.62 x 51 brass and Win. 9mm NATO.
res45 is offline  
 
Page generated in 0.02245 seconds with 8 queries