Got it out !!
Had to tap it lightly, but got it easier than the first time I did it.
In the two pics you can tell what needs to be done.
1) Soft area - the PAM made the JB Weld not cure 100 percent, easy fix, I'll grind it off, and redo JB Weld right there, or grind off and press a brass shim in there, that's the area where the wood got ripped off when I did it the first time.
2) Remove - that area marked, need to remove approximately 1/4 inch, since the Russian manual pics I've seen said leave that area free from touching metal.
3) Relieve the area where the ejector is.
4) Add a tiny bit more on the sides/edges, to get a nice uniform touch.
5) The front of the receiver, actually where the barrel is, no biggy, it went too far, but I have tape underneath it.
I may maybe not maybe have elevated the barrel a tiny bit too much, maybe, oh well just means it'll be easier to free float the barrel before I do the corking and felt wrap.
|