The Firing Line Forums - View Single Post - Lee Push-Through Sizing Die Too Small

Axelwik · May 22, 2012, 08:08 AM

Thanks for all the advice.

I'm probably not going to run out and spend hundreds on a Lubrisizer and dies because of one Lee die; and since these sizing kits are so inexpensive I'll try honing it at home.

I appreciate the input.

May 22, 2012, 08:08 AM	#10
Axelwik Senior Member Join Date: March 12, 2012 Location: Land of Enchantment Posts: 436	Thanks for all the advice. I'm probably not going to run out and spend hundreds on a Lubrisizer and dies because of one Lee die; and since these sizing kits are so inexpensive I'll try honing it at home. I appreciate the input.