Sure, give it a whirl. Below is a link that might help. There are likely some YouTube vids on the process, too.
Be aware the j-frame's spring is a coil, rather than a leaf, as shown in the link. Also, I'd remove tension in the mainspring before removing the sideplate (it's done after in the link).
Read over the process beforehand so there's no surprises. A little bitty spring that launches tends to put a damper on the fun. When in doubt, do the disassembly in a shoebox or even a ziplock bag.
Use a screwdriver with the proper hollow ground bits.
Don't use WD40. It's designed as a
Water
Displacer, not as a cleaner or lubricant. Besides, there are plenty of quality gun cleaners & lubes available. If you don't want to spring for an actual gun lube, use
ATF.
http://www.thehighroad.org/showthread.php?t=397027