View Single Post
Old August 21, 2002, 04:34 PM   #13
Bogie
Senior Member
 
Join Date: June 5, 2000
Location: Job hunting on the road...
Posts: 3,827
Oh heck...

Dunno what you'll spend on the bullets...

A jug of 4895 will set you back around $90ish.

Priming tool will run around $15.

The Lee trimmers will cost you around $10ish; the Wilson around $40ish, and with care will last the rest of your life.

Lyman manual is around $20ish - check Ebay or Amazon's used stuff...

The dies should be under $30ish.

Die wax should be around $4, and the spray runs around $8/can.

Cheapo dial caliper - $15 from Harbor Freight. I've got a plastic Lyman one you can have, but you probably wouldn't want it.

You could probably get along without the caliper - Get the Lee trimmers, and just load to stay inside magazine-max-length, and you should be okay.
__________________
Job hunting, but helping a friend out at www.vikingmachineusa.com - and learning the finer aspects of becoming a precision machinist.

And making the world's greatest bottle openers!
Bogie is offline  
 
Page generated in 0.03090 seconds with 8 queries