View Single Post
Old May 22, 2012, 06:34 AM   #7
dahermit
Senior Member
 
Join Date: October 28, 2006
Location: South Central Michigan...near
Posts: 6,501
Quote:
What's the best (and inexpensive) way to do it?
"Best" way is to have Lee handle the problem...and the will because if it produces a bullet that is a different diameter from what is stamped on the die, it is likely faulty (or your alloy is springing back). Also, they will not hone the die out of round, where you may do so by using home methods. The "inexpensive" way is to follow the instructions given in posts here, and hope for the best...learning by doing results in lots of things in the trash bin. Take your choice.
dahermit is offline  
 
Page generated in 0.03842 seconds with 8 queries