View Single Post
Old November 6, 2013, 12:33 PM   #1
Eomfd
Junior Member
 
Join Date: November 5, 2013
Location: California
Posts: 9
Low pressure problem?

I am new to reloading and started my first 9mm batch the other day. I am loading 115 gr rainer plated RN with new Remington brass, CCI primer, and IMR SR 4756. I followed my load data which stated the starting charge be 4.5 grains. I loaded 20 rounds and each round I fired would not cycle to the next round. Also, my barrel would be extremely dirty only after a few rounds. Here is a picture of my casings after I would manually cycle each round. Any help out advice would be greatly appreciated.
Attached Images
File Type: jpg Casing.jpg (21.9 KB, 74 views)
File Type: jpg Barrel.jpg (14.9 KB, 53 views)

Last edited by Eomfd; November 6, 2013 at 12:50 PM.
Eomfd is offline  
 
Page generated in 0.04062 seconds with 9 queries