The Firing Line Forums - View Single Post

jrothWA · February 22, 2007, 01:11 AM

remove forearm screw from barrel extension,
pull op handle to rear and hold it.
Rotate barrel up and back (the op rod needs to be back to seperate from stock).
Make two 5/16 diameter by .73" long slave pin to push out the two pins visible in the lower receiver.
This will allow the removal trigger assembly.

February 22, 2007, 01:11 AM	#9
jrothWA Senior Member Join Date: November 11, 2006 Posts: 2,519	m100 disassembly.. remove forearm screw from barrel extension, pull op handle to rear and hold it. Rotate barrel up and back (the op rod needs to be back to seperate from stock). Make two 5/16 diameter by .73" long slave pin to push out the two pins visible in the lower receiver. This will allow the removal trigger assembly.