Quote:
Are you guys saying that the taper crimp is doing the swageing, or the sizer ring? Also, it isn't hard to pull a bullet after running it through this die. I've done it and still measured .452 on my boolits.
|
The sizer ring. Some FCDs are tighter than others. Mine is on the tight side. I could open it up a bit with some heavy polishing but I have left it as is. When I pull my cast bullets I get about a .001" lip at the case mouth, which tapers to .0005" at the base of the bullet. Here is a pic I posted in a previous thread (middle is a fresh bullet, the bottom one was pulled)