The Firing Line Forums - View Single Post

Shadi Khalil · May 30, 2009, 04:13 PM

I owned 4 Taurus revolvers and three of them had timing problems, 2 of them had the timing problems and cylinder lock up problems. All of them would work screws loose after a while, no matter how much lock-tite I used. Dealing with Taurus CS was a nightmare, they held on to one pistol for over three months and returned it un-repaired. I took one to a smith (617) and when that worked it was a joy to shoot. Other than that, I can whole hardly advise you to avoid the lure of the Taurus.

May 30, 2009, 04:13 PM	#7
Shadi Khalil Senior Member Join Date: September 23, 2006 Location: Alexandria, VA Posts: 5,210	I owned 4 Taurus revolvers and three of them had timing problems, 2 of them had the timing problems and cylinder lock up problems. All of them would work screws loose after a while, no matter how much lock-tite I used. Dealing with Taurus CS was a nightmare, they held on to one pistol for over three months and returned it un-repaired. I took one to a smith (617) and when that worked it was a joy to shoot. Other than that, I can whole hardly advise you to avoid the lure of the Taurus.