View Single Post
Old January 7, 2013, 11:05 PM   #6
CTS
Senior Member
 
Join Date: November 6, 2011
Location: NE Georgia
Posts: 1,070
Are you sure it's off center or does the shoddy welding just make it look that way? I have never done this, not living in a place that requires such nonsense but, if you are planning to weld the brake in the position you want then what would be the purpose of using the crush washer? I was under the impression that the crush washer was there for the purpose of indexing the brake or flash suppressor. Not needed if being welded, or at least you wouldn't think so.
CTS is offline  
 
Page generated in 0.03381 seconds with 8 queries