220v wiring
Surely there are some electricians on this board but that doesn't sound right. 220v typically has two "hot" wires, a "neutral" and a ground, you can buy a pre-wired plug to fit your dryer that will use braided copper (superior to solid for this application) or use 10/3.
You do not want to solder connections in this case, solder has a lower melting point than lead! You need to make solid mechanical connections at the pot.
If you do not have an instruction sheet for this pot have an electrician do it, hopefully one that is a shooting buddy and will trade his time for boolits.
Last edited by darkroommike; November 1, 2011 at 06:51 AM.
Reason: expansion of post
|