Yes I lube them with RCBS case lube on the pad 5 or so at a time and was lubing the inside of the case neck 1 out of 5 or so, in order to keep it from building up heavily. I stopped using the lee stuff because it seemed to just cake on the pin and was hard to get off there. I dont mind lubing the inside of the case if I need to I just wasnt sure if I need to remove it from the inside before I load them and put the bullet down into, I remember reading not to allow the lube on the outside of the case neck and something about not putting it down inside where the powder rests but I couldnt remember if it was the same for the actual neck. If so a quick tumble to help remove the lube and i would be good. It just seemed like one more added step and more time to remove media from the flash hole. So I figured I would ask the more knowlegable folks for the information. Thank you again for the help.
|