View Single Post
Old January 31, 2013, 10:12 AM   #13
Hal
Senior Member
 
Join Date: October 9, 1998
Location: Ohio USA
Posts: 8,563
A 19-3 would have been smack in the middle of the Punta years.
Bangor Punta owned S&W from 1965 until 1984.

QC during those years wasn't as good as it should have been & a whole lot of stuff was made that's borderline - such as the "just barely squeaks by being in spec" cylinder gap on your 19.

The drop in QC during those years was a fact.
The actual drop in QC wasn't all that bad.....it was greatly exaggerated.

It did used to have an effect on the value though.
That's one of the reasons I sought out M19's made during that period - they were excellent values.

And more importantly - all the ones I picked up were exceptionally good shooters.

Honestly though - if everything else works as it should then the CG isn't anything to worry about.

If it bothers you all that much, find someone with a chrono and clock some loads through it and see what it shows.
Hal is offline  
 
Page generated in 0.02397 seconds with 8 queries