Quote:
|
What's the worst that could happen?
|
The problem is more with getting a reliable bond to the existing metal. A scrupulously clean surface "might" do it, but a long, razor-thin piece of epoxy material that comes un-stuck at just the wrong time could
seriously jam up the works. The presence of heat (from firing a number of rounds), heat cycling (cold to hot and back again, who-knows-how-many times), lubrication (and what is used to lube the pistol), and the repeated jarring impact of the slide cycling x-many times are all variables that are difficult to account for.
Bottom line--I'm sure there are better ways to tighten up frame/slide fit.