okay, I'm getting really frustrated here:
2 cases were put through my sizing /depriming die. I am certain that my sizing die touches the shell plate when the platform is raised. When I saw that one case didn't seek I put it back to the sizing the priming die a 2nd time with no change.One case seats fine in my cartridge gauge, the other seats up. Below are some images to help explain what's going on.
The 2 cases sitting next to each other the one with the X doesn't seat in the cartridge gauge:
http://imageshack.us/a/img707/2891/1tt5.jpg
the 1st case seating properly down in the cartridge gauge:
http://imageshack.us/a/img819/866/xicv.jpg
the 2nd case seating up in the cartridge gauge:
http://imageshack.us/a/img577/4757/im8q.jpg
disclosing powder put on the case to show it's binding just below the extractor groove:
http://imageshack.us/a/img850/4071/e5lk.jpg
please help