View Single Post
Old December 11, 2012, 01:50 PM   #16
Tom68
Senior Member
 
Join Date: September 20, 2011
Location: Alabama
Posts: 349
dawg, i'm like many of the previous posters: H4831SC is my standby in the .270, although I've gotten near as good a result from IMR 4350, both using the Nosler 130gr BT.

I can tell by your OP that buying a new powder for experimentation sake isn't your highest wish, but for reduced loads i've used A-5744; .270, .243, .30/06 and .308 all worked well with this powder. I did have to email Accurate for load data, but they were very quick with a reply.

I have IMR 4895 and 4064 on hand, but quite honestly it has never occurred to me to try them in the .270 since the slower powders worked so well.
Tom68 is offline  
 
Page generated in 0.03314 seconds with 8 queries