View Single Post
Old July 6, 2011, 02:12 PM   #4
GURU1911
Senior Member
 
Join Date: December 22, 2010
Location: SEALY, THE REPUBLIC OF TEXAS
Posts: 501
Pistol refinishing

All of my personal experience has been with "robar" in arizona. I am especially gung-ho on their famous "np3" finish. It is expensive, but the lifetime benefits make the initial cost really cheap !!!!!

I suggested "cca" in tenn as an alternative, as their $$$$ is lower than robar's & this may be of concern with you.

Regardless of who refinishes your cz pistol, the pistol will be detail stripped & the internal parts will be plated along with the slide, frame, & the outside of the barrel. Your pistol will arrive completely assembled & ready for you to shoot. Lube well & give the weapon about 200 rounds to smooth things out after plating.

If possible, take some before pics & some after the refinish has been done. Then send the pics to the smithy section & a short memo about your experience with the platter of your choice.

Guru1911
__________________
NRA LIFE MEMBER (1984) & PRESIDENT: S.W. LA. R&P CLUB, LAKE CHARLES, LOUISIANA (1994-1999)
METALLIC CARTRIDGE RELOADER (1977) & GENTILE CHRISTIAN ZIONIST INFIDEL !!!

"THERE AIN'T TOO MANY THINGS THAT YOU CAN'T FIX, WITH $500 DOLLARS OR A .30-06"
GURU1911 is offline  
 
Page generated in 0.02949 seconds with 8 queries