View Single Post
Old July 22, 2012, 10:08 AM   #22
cryogenic419
Senior Member
 
Join Date: March 29, 2009
Location: NW Ohio
Posts: 569
It really does sound like it is a timing/pawl adjustment issue. All it takes is being a hair off to jam up. Even once you set it up for perfection, parts do wear and you will have to set it again eventually.

Just in case you had any questions on pawl adjustments, read the link here.

http://thefiringline.com/forums/showthread.php?t=368171

One other thing that just occured to me. I know there is a slight amount of wiggle room when a case is in the shellholder. How level is the surface your press is mounted to? If there was only a slight amount of tilt to one side, I could see that being enough to cause the case to lean to one side as well and have trouble entering the die.

Something else you may want to look into. Read the part about squaring up your dies. It may help.

http://www.sierrabullets.com/index.c...sue=1#loadtip1
cryogenic419 is offline  
 
Page generated in 0.02961 seconds with 8 queries